Hello,
I was looking for some advise for usage and installation of a wheel probe used for mileage and speed recording during road rallies.
I hope this is the right place for this kind of question.
Thanks,
Mike
You install it on one of the front wheel spindles with a simple bracket. It picks up the head of the wheel studs from the back of the disc. If you are using a Terratrip or similar it will have inputs for two probes, which can be installed, but that is belt and braces.
Cheers,
H
I replaced the wheel bearings yesterday, so here's a couple of photos.
Cheers,
Attached image(s)
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)