Printable Version of Topic

Posted by: Randal May 30 2013, 10:54 AM

After Bill and I installed the steering wheel quickner I put on my 12.25" steering wheel. This ended up being to small and very difficult to turn, so went to a 13.75" wheel. The one I bought was also a deep dish so the wheel was about 2" closer to me.

So the bigger deep dish bigger wheel was actually easier to turn, but to big for my personal geometry and being closer I ended up crashing my elbow into the sharp part of the Kirkey seat. Ouch!

Now have gone to something in between, i.e., 330mm or about 12.9 inches and flat.

Still looking to install an in-line steering torque motor (Prius) after I get back from Cascade Lakes.

Here is a picture of the new 12.9" flat wheel.







Here is the old wheel position