I have a standard magnesium transmission in my 914-4 vintage race car. My race shop recommends a billet aluminum intermediate plate for more rigidity and longer life. I have had zero problems with the current unit. The price tag for removing the transmission, shipping it to Gbox, making the modification and reinstalling it seems high at $3,300.
Has anyone made this change? Is it worth it and is the price in line?
Thanks
Seek out Dr. Evil. That's a steep price. YIKES!
And what HP you plan or running thru the transmission is key. The current plate has held up for 40+ years. Rebuild it and your fine for another 40 years.
Doc will advise you the right way and give valuable insight, etc.
Steve
Enthusiastic +1 for consulting with Dr Evil
If you decide to get the work done, my 'tip' is
http://t.homedepot.com/p/27-gal-Strong-Box-Plastic-Storage-Tote-in-Black-and-Yellow-292015/202976606/
Then look into Fedex for ground shipping. I've done it for around $90 coast to coast a couple of times...
I did replace one of my intermediate plates but only because finding some cracks while changing out some gear ratios
Seems a like a lot of money for something you say is already working fine. I would put some of that cash to building a spare trans. So if you do have an issue, you pop in the spare while the first one gets fixed.
The price is definitely steep as you can get a newly rebuilt (with new parts even) for less than that. IIRC, there was a rebuilt race trans with LSD for about that in the classifieds a few weeks ago.
The ONLY reason the price is high is that the pinion drive shaft is "paired" with the intermediate plate.
If you swap out either one of those, you have to reset the pinion shaft depth which few people know how to do correctly.
Dr. Evil can definitely do it, but otherwise not a DIY operation.
That is probably a reasonable price. You have maybe 6 hours labor to pull and install the transmission, then shipping it out to GBox, parts and labor there, and freight back. The intermediate plate and bearing retainer are almost $600 by themselves.
Is it needed? I can tell you I won't build another race car transmission without cryo treatment, REM polish, billet intermediate plate, and billet side cover. I build mine local, but I would send it to Roger at California Motorsports if I was not going to do it myself.
"I have had zero problems with the current unit. "
Why I thought a low cost spare might be an alternative to breaking apart a good running trans.
An aluminum intermediate plate will no doubt hold up better than a stock magnesium unit. But I'm surprised that for 140 hp it would be necessary. I've been running 260 hp through my 901 for many years without an issue.
Scott
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)