The engine that came with my new track 914 also came with the 911 fan conversion from FAT. I haven't gotten a very good answer from Fat on what other tins I should install with it. Obviously upper and side tins are replaced, but how about the lowers? Any other sheetmetal or deflectors that are part of the system? It was all apart when I got it, and so far I've found (or not found) some other missing bits as it wasn't disassembled or cataloged upon disassembly very well.
Thx.
Pictures would help but from my minds eye,
the DTM shroud replaces both the L&R top tins as well as the relocation of the impeller makes the front 2 piece section unnecessary.
The back upright is still necessary as well as the tin section beneath/between the head & tubes and the tin wrapping the rear of the cylinders are necessary.
Not sure of the piece directing air to the stock oil cooler location nor on the opposite side for the alt?
Isn't the alt relocated?
Not that mine is right, I did blow it up after all, but mine only had the lower tin, under the cylinders installed, no other tin.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)