 Electric Question, Wiring to coil and Dist |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| 914coop |
 Aug 19 2010, 04:39 PM
Post
#1
|
|
Member  Group: Members Posts: 214 Joined: 5-September 08 From: Minneapolis Member No.: 9,514 Region Association: Northstar Region  |
Had a wire melt down on top of cylinder #3 I believe to be a bad ground issue. Have cleaned up the FI wiring and Fix a section of wire going to the dist and coil. Now when testing the connections the black wire seems to carry 12 volts with the ignition on, red seems to have very little 3 volts not constant with the ignition on goes to ground with the ignition off. Green wire have not tested believe it goes to condenser which I am no longer using as switched to electronic Ignition. Yellow wire ???? was cut and taped in the harness not sure what it was for. Issues is I am getting no spark form the coil wire and Looking for Ideas on what to look for next
|
   |
 
|
Posts in this topic
914coop Electric Question Aug 19 2010, 04:39 PM
underthetire All electronics are the same that i've seen, r... Aug 19 2010, 05:11 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd June 2024 - 10:29 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.