 2 hour oil cooler install, Preparations for WCC |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Demick |
 Feb 13 2005, 09:41 PM
Post
#1
|
|
Ernie made me do it!  Group: Benefactors Posts: 2,312 Joined: 6-February 03 From: Pleasanton, CA Member No.: 257   |
I finally got around to installing my aux oil cooler. Used a Mocal thermostatic sandwich plate and Derale fan/cooler. Aeroquip blue hose with -8AN push on ends connected it up. Hose runs next to valve cover and zip ties to the wire bales (should make valve adjustments interesting). I removed the heater J tube on the passenger side to route the cooler lines. Since that J tube was just capped anyway, I just removed the J tube and put the cap where the J tube normall attaches to the heat exchangers. So there is no change to the heating system.
Demick Attached image(s) 
|
   |
 
|
Posts in this topic
Demick 2 hour oil cooler install Feb 13 2005, 09:41 PM
Demick And here is the sandwich adapter showing oil line ... Feb 13 2005, 09:42 PM Demick more Feb 13 2005, 09:43 PM SirAndy Feb 13 2005, 10:01 PM Demick Air does not blow onto the cooler lines. There is... Feb 13 2005, 10:07 PM SirAndy Feb 13 2005, 10:09 PM Aaron Cox <... Feb 13 2005, 10:11 PM SirAndy Feb 13 2005, 10:11 PM trekkor 
