 Help: Ignition problem with 914-6 in Sunnyvale, Will not start. |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| bfrymire |
 Mar 16 2008, 07:49 PM
Post
#1
|
|
Salsaholic  Group: Members Posts: 590 Joined: 1-August 04 From: Sunnyvale, CA Member No.: 2,431 Region Association: Northern California  |
Hello,
I am stuck. I have a 914-6 that will not start. It was running and started running poorly, and I replaced/upgraded several components. I am now using: Brand new: Pertronix coil (3 ohm), Ignitor module (still have the old one.), and a Second Stike digitial control unit. No spark at all. I have wired out the second strike, hot wired the car directly from the battery to the coil, and strapped the - side to engine ground to be sure it wasn't getting the correct power. (I wired it the regular way, through the harness, I did the above to troubleshoot.) Any ideas? I have missed two Autocrosses now! (IMG:style_emoticons/default/wink.gif) I have checked eveything else also, such as gas to the carbs, and fuel pressure. (Not related to no spark, but just being sure.) Help! -- brett |
   |
 
|
Posts in this topic
bfrymire Help: Ignition problem with 914-6 in Sunnyvale Mar 16 2008, 07:49 PM
911quest When you say no spark where are you checking it at... Mar 16 2008, 08:14 PM
bfrymire
When you say no spark where are you checking it a... Mar 16 2008, 08:24 PM bfrymire Fixed it. Back on the road again. :Qarl:
Turn... Mar 21 2008, 08:05 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 16th June 2024 - 06:21 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.