 Holly fuel pump |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| eimc |
 Aug 3 2014, 05:21 PM
Post
#1
|
|
Newbie  Group: Members Posts: 45 Joined: 2-October 04 From: Mechanicsburg Penna. Member No.: 2,873 Region Association: None 
 |
Iam running a holly red fuel pump on my 914-6 race car . It's a 2.2 with 40mm webers.I had hesitation problems after about 4 laps at pittsburgh grand prix. I cleaned the idle(progresion) jets( 4were clogged) started the car and it sounded ok. As I was checking in the trunk for fuel leaks I felt the fuel pump and it was hot. Then I checked the fuel pressure at the regulator and it was 3 pounds . Checked both fuel filters and cleaned , blew air in all lines to check for restrictions and everything ok. Mounted another holly red fuel pump and ran for 10 minutes and it was hot to the touch also and fuel pressure would not go above 3 pounds. I presume pressure should be 6 to 9 pounds ? Anyone have any opions? Thanks Paul
|
   |
 
|
Posts in this topic
eimc Holly fuel pump Aug 3 2014, 05:21 PM
Matt Romanowski I have a Holly blue pump and it's always hot. ... Aug 3 2014, 07:18 PM vintage914racer I have a holley blue and it is also hot to the tou... Aug 3 2014, 08:56 PM eimc
Iam running a holly red fuel pump on my 914-6 rac... Aug 4 2014, 08:04 AM
slivel
Iam running a holly red fuel pump on my 914-6 ra... Aug 4 2014, 10:24 AM J P Stein I put a Facet pump in with no regulator. (noisy su... Aug 4 2014, 11:00 AM ETMracing What do you all use for thread sealant on fuel ite... Aug 11 2014, 03:05 PM stownsen914
What do you all use for thread sealant on fuel it... Aug 11 2014, 03:35 PM campbellcj I can't remember if I used the special sealant... Aug 11 2014, 09:05 PM jd74914 I've used both regular teflon tape and pipe do... Aug 12 2014, 07:41 AM brant AN fittings seal on their matting face
BY DESIGN
... Aug 12 2014, 08:52 AM J P Stein IIRC, I had 3-4 NPT connections....the rest were A... Aug 12 2014, 09:12 PM campbellcj Likewise - tape only on the pipe threads. Brant is... Aug 12 2014, 10:23 PM Racer Chris I generally avoid using teflon tape on oil and fue... Aug 13 2014, 07:55 AM ETMracing Sounds good to me, I knew the AN lines should seal... Aug 14 2014, 02:43 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th June 2024 - 03:32 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.