Cut off switch installation |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Cut off switch installation |
jhynesrockmtn |
May 19 2021, 08:00 AM
Post
#1
|
Member Group: Members Posts: 420 Joined: 13-June 16 From: spokane wa Member No.: 20,100 Region Association: Pacific Northwest |
In my continuing efforts to bring this car back to life and be able to run some vintage race events I have to wire in an electrical system kill switch. The original builder went for a GT clone and installed a Bosch 2 pole switch but it was just for show and not wired to anything. He ran AX and a few PCA time trials and apparently didn't need it to meet tech.
This is a 6 cylinder conversion with a factory 6 dash and ignition switch. I've read multiple threads with suggestions for 2 pole, 4 pole and 6 pole switches and various install locations. Frankly I'm confused and could use some help. I'm looking for a wiring diagram and suggestions for either keeping and using this switch or swapping it out for something else. I'll keep it in this location. |
Lo-Fi Version | Time is now: 1st June 2024 - 12:38 AM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |