jhkjkl

Attached thumbnail(s)

Once I got the bushings to fit, I stacked the washers to draw the bushings into their final locations.

Attached thumbnail(s)

I had to use a rat tail and a small bore honing tool to fix the trailng arms, they were out of round. This side of the trailing arm was out of round, the other side was fine, this is the furthest that the bushings would go in.

Attached thumbnail(s)

This is the most recent batch to come back;

Attached thumbnail(s)

[att
achmentid=5912]

Attached thumbnail(s)

Cleaned up and bagged the wiring in preperation for paint;

Attached thumbnail(s)

Nuts, Bolts and Misc Parts dipped in Vineger, and readied for plating.

Attached thumbnail(s)

Attached thumbnail(s)

Lots of sanding now. Using 360 grit wet or dry.

Attached thumbnail(s)