Printable version of Entry

Click here to view this entry in its original format

rallysport70's Blog

New Jack Post Welded

I welded the new jack post to my wheel house section that I'm replacing. Haven't ground any of it yet, but maybe over the weekend. I hope to finish prepping the inside and get this piece welded in so I can start to address the engine compartment, shelf, and firewall. The pic taken in place is just an initial test fit. The actual square tube rotated slightly and is not perfectly aligned. I don't think it will impact anything.

Attached thumbnail(s)
Attached Image Attached Image

Powered by Invision Community Blog (
© Invision Power Services (