 Tailshifter shift rod refurb..., ..at the tranny end. Anyone have a photo? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
  |
| slu234 |
  Apr 7 2010, 07:46 AM
Post
#1
|
|
Member  Group: Members Posts: 57 Joined: 20-January 09 From: Staunton, VA Member No.: 9,949 Region Association: MidAtlantic Region  |
My `70 tailshift rod is worn at the tranny end. This is where the finger drops down into the tranny shift lever.
Does anyone have some photos they could share of what an unworn or refurbished shift rod finger looks like? Side shift conversion is not in the cards at this point in the game. Thanks, Brian |
   |
 
|
| realred914 |
Apr 7 2010, 11:38 PM
Post
#2
|
|
Senior Member Group: Retired Members Posts: 1,086 Joined: 1-April 10 From: california Member No.: 11,541 Region Association: None |
QUOTE(slu234 @ Apr 7 2010, 06:46 AM)  My `70 tailshift rod is worn at the tranny end. This is where the finger drops down into the tranny shift lever. Does anyone have some photos they could share of what an unworn or refurbished shift rod finger looks like? Side shift conversion is not in the cards at this point in the game. Thanks, Brian hanyes book fig 5.28 shows it kind of small. the tail shift is good, with new bushing, not all that bad at all. hardly worth the conversion effort if youget your all re-bushed. save yoru money!!!! |
|
|
|
| jimkelly |
Apr 8 2010, 06:33 AM
Post
#3
|
|
Delaware USA Group: Members Posts: 4,969 Joined: 5-August 04 From: Delaware, USA Member No.: 2,460 Region Association: MidAtlantic Region |
for those who would like a photo of a non-refurbished one.
Attached image(s) 
|
|
|
|
| slu234 |
Apr 8 2010, 11:45 AM
Post
#4
|
|
Member Group: Members Posts: 57 Joined: 20-January 09 From: Staunton, VA Member No.: 9,949 Region Association: MidAtlantic Region |
Thanks for the photo!! That will help a bunch. Wasn't sure if some of the areas were worn or machined that way.
Thanks, Brian |
|
|
|
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st June 2024 - 02:08 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.