 Taco Plate Gasket, paper or rubber ? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
  |
| Olympic 914 |
 Aug 18 2017, 07:52 AM
Post
#1
|
 Group: Members Posts: 1,675 Joined: 7-July 11 From: Pittsburgh PA Member No.: 13,287 Region Association: North East States 
 |
will be installing a taco plate with temp sender on my next oil change.
I see the PET lists two gaskets for this application. 021 101 269A is a rubber o-ring for non sender plate 039 101 287 is a paper gasket. for the sender plate. little copper seals are the same for both. I remember using the rubber o-ring when installing the non-sender taco plate. why is there a different gasket for the sender version? Are they interchangeable? |
   |
 
|
| era vulgaris |
Aug 18 2017, 08:44 AM
Post
#2
|
|
J is for Genius Group: Members Posts: 982 Joined: 10-November 13 From: Raleigh, NC Member No.: 16,629 Region Association: South East States |
You'll need both. It's been over a year since I did this on my old car, but IIRC there's one seal that's for the plate that holds the sender, and then one for the cover plate. I can't remember which is which, but it'll be obvious when you're putting them on.
|
|
|
|
| Valy |
Aug 18 2017, 09:12 AM
Post
#3
|
|
Senior Member Group: Members Posts: 1,677 Joined: 6-April 10 From: Sunnyvale, CA Member No.: 11,573 Region Association: Northern California |
You need both and the copper washers.
The paper gasket must be replaced, the others can be reused several times. See my signature for the paper gasket templates. |
|
|
|
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 7th June 2024 - 03:56 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.