 What is used to seal where the foam is removed in the quarter |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
  |
| seanpaulmc |
 Oct 31 2026, 03:10 PM
Post
#1
|
|
Member  Group: Members Posts: 467 Joined: 6-December 16 From: Orlando, FL Member No.: 20,649 Region Association: South East States 
 |
When removing the factory foam residing in the rear quarter panel above and to the outside of the taillight an open void will be left. The cavity needs to be treated for rust prevention with paint, primer, etc.
Does anyone block off this cavity to prevent debris build up now that it has become a catch can? If so, how? With what? Thanks   |
   |
 
|
| mepstein |
Oct 31 2026, 03:52 PM
Post
#2
|
|
914-6 GT in waiting Group: Members Posts: 20,966 Joined: 19-September 09 From: Landenberg, PA/Wilmington, DE Member No.: 10,825 Region Association: MidAtlantic Region
|
Some people use plastic fender liners. I plan to just prime and paint. I’ll clean it up as needed. Definitely not putting foam back in that spot - or anywhere on the car.
|
 |
|
|
3 User(s) are reading this topic (3 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 31st October 2026 - 08:21 PM |
Invision Power Board
v9.1.4 © 2026 IPS, Inc.