 4-2-1 Exhaust, Suspect small leaks upstream of O2 Sensor |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
  |
| yarin |
 May 1 2006, 05:24 AM
Post
#1
|
|
'14-X'in FOOL  Group: Members Posts: 988 Joined: 13-May 03 From: Guttenberg, NJ Member No.: 693 Region Association: North East States  |
I've got a 4-2-1 header system i'm using. During tuning my Megasuirt on decel I see full lean on the WBO2. By accident I ran the engine without a bung plugged upstream of the O2 sensor and saw full lean at idle. Is it possible i'm having a similar issue?
Here is a pic of the exaust. All the flanges are clamped down, seals are tight. However it just seems to me with this design there will be always be some sort of leak since there are no gaskets used. Can I use any type of compound or sealant where the tubes mate? I thought of exhaust putty but i'm sure thats just going to crack away after it cures. Thoughts? My WBO2 sensor is located at the collector right before the muffler. Attached image(s) 
|
   |
 
|
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 15th July 2025 - 03:29 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.