 Another 'easy' question for someone, I'm sure., Just a couple dimensions I need |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| BMXerror |
 Dec 22 2009, 11:30 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,705 Joined: 8-April 06 From: Hesperia Ca Member No.: 5,842  |
Does anybody know the size difference between the 1.7 and 2.0 heads where the cylinder slips in? Actually dimensions would be nice. Bore on the heads, or OD of the cylinders. Either one. Doesn't matter.
Also, is there a difference at the bottom too? I.E., is there a larger bore on the 2.0 case for the sleeves? Thanks in advance. Mark D. |
   |
 
|
  |
Replies(1 - 3)
| VaccaRabite |
Dec 23 2009, 07:06 AM
Post
#2
|
|
En Garde! Group: Admin Posts: 13,729 Joined: 15-December 03 From: Dallastown, PA Member No.: 1,435 Region Association: MidAtlantic Region 
|
Yes, it is different, but I don't know by how much. measure the OD of the 1.7 and the OD of the 2.0 and that will tell you. If you are using 1.7 heads on a 2.0 you have to have them cut for the bigger cylinders.
Zach |
|
|
|
| Cap'n Krusty |
Dec 23 2009, 08:50 AM
Post
#3
|
|
Cap'n Krusty Group: Members Posts: 10,794 Joined: 24-June 04 From: Santa Maria, CA Member No.: 2,246 Region Association: Central California |
Top's different, the base of the cylinders is the same. The Cap'n
|
|
|
|
| Mark Henry |
Dec 23 2009, 09:14 AM
Post
#4
|
|
that's what I do! Group: Members Posts: 20,065 Joined: 27-December 02 From: Port Hope, Ontario Member No.: 26 Region Association: Canada |
Heads should only be done with the new cylinder in hand, allow about .015 over on the flycut.
It works, I've done it several times, but I'd try to find a set of 1800's first. |
|
|
|
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 03:46 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.