 Is this piece removable?, Backer for latch striker |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| TargaToy |
 Oct 3 2015, 08:21 PM
Post
#1
|
|
-NONSOLIS RADIOS SEDIOUIS FULMINA MITTO-  Group: Members Posts: 692 Joined: 26-March 10 From: DelMarVa Peninsula Member No.: 11,509 Region Association: MidAtlantic Region 
 |
Replacing another chunk of my car and I'm doing some clean-up of the old seam sealer and undercoating before I start fitting the new metal. Does the backer for the door striker come off? It appears to be a single piece with 4 threaded tubes...and it looks like it may have been held in place by tape until the 4 machine screws were installed at the factory. But the joker is really fused in place. I don't want to pry too hard if it's spot welded.
  |
   |
 
|
  |
Replies(1 - 2)
| ejm |
Oct 3 2015, 08:33 PM
Post
#2
|
|
I can see the light at the end of the tunnel Group: Members Posts: 2,693 Joined: 3-February 03 From: Massachusetts Member No.: 224 Region Association: None |
Not welded, Needs to float so the striker plate can be adjusted. Early ones had a metal tab to retain them, later ones enclosed in a box.
|
 |
|
| TargaToy |
Oct 3 2015, 08:37 PM
Post
#3
|
|
-NONSOLIS RADIOS SEDIOUIS FULMINA MITTO- Group: Members Posts: 692 Joined: 26-March 10 From: DelMarVa Peninsula Member No.: 11,509 Region Association: MidAtlantic Region
|
Thanks a lot. It's a 72 so that must be the metal retaining strap I'm seeing.
|
|
|
|
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 8th June 2024 - 01:20 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.