Home  |  Forums  |  914 Info  |  Blogs
 
914World.com - The fastest growing online 914 community!
 
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.
 

Welcome Guest ( Log In | Register )

> Major difficulty getting into reverse and first. It was working and then it wasn’t.
914xr75
post Aug 5 2026, 12:14 PM
Post #1


Member
**

Group: Members
Posts: 230
Joined: 24-March 18
From: Whittier, CA
Member No.: 21,996
Region Association: Southern California



My daughter’s 73 is having a very hard time shifting into reverse and first. A couple years ago I replaced all the bushings down below, but I did not replace anything in the console area.

While going about 2 miles an hour, I can get it into first, but reverse is very difficult. I’ve got it up on jackstands right now and I’m about to put my level one mechanical eye on it. Just thought I’d throw this out in case anyone knows what I need to look for before I get down under Lil’s 914—-again.

She’ll be helping me this time.
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
 
Reply to this topicStart new topic
Replies(1 - 2)
Jack Standz
post Aug 5 2026, 02:56 PM
Post #2


Senior Member
***

Group: Members
Posts: 896
Joined: 15-November 19
From: Happy Place (& surrounding area)
Member No.: 23,644
Region Association: None



Maybe the first place to look is where the front and rear shift rods connect under the rubber boot by the firewall. Is the cone screw loose? Also, check the bushing there and all the bushings back to the transmission.
User is online!Profile CardPM
Go to the top of the page
+Quote Post
mark04usa
post Aug 5 2026, 03:00 PM
Post #3


'70 1.7 Tangerine
**

Group: Members
Posts: 366
Joined: 14-September 09
From: Austin TX
Member No.: 10,805
Region Association: Southwest Region



Be sure that the clutch is disengaging. If out of adjustment, or if the clutch cable tube has broken loose, could be cause of your 1st/reverse problem.
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Reply to this topicStart new topic
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:

 



- Lo-Fi Version Time is now: 5th August 2026 - 03:41 PM
...