|
|

|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| seanpaulmc |
Nov 15 2026, 05:05 PM
Post
#1
|
|
Member ![]() ![]() Group: Members Posts: 480 Joined: 6-December 16 From: Orlando, FL Member No.: 20,649 Region Association: South East States
|
Hi World -
Looking for some advice from those who’ve gone before. TIA I am beginning to plan installation of the rear sway bar brackets. ![]() ![]() 1. Should the bracket be bent to flatten against the trunk pan for welding? Same both sides of course. I do not have the shock bolts in yet. One side is proving quite difficult to extract. I say this because of the next question. 2. Does the sway bar need to be mocked up (installed) to get alignment between each side, or is the alignment forgiving enough to eyeball? Thank you |
![]() ![]() |
| L-Jet914 |
Nov 15 2026, 05:27 PM
Post
#2
|
|
Member ![]() ![]() Group: Members Posts: 438 Joined: 24-October 12 From: Davis, CA Member No.: 15,080 Region Association: Northern California |
Hi World - Looking for some advice from those who’ve gone before. TIA I am beginning to plan installation of the rear sway bar brackets. ![]() ![]() 1. Should the bracket be bent to flatten against the trunk pan for welding? Same both sides of course. I do not have the shock bolts in yet. One side is proving quite difficult to extract. I say this because of the next question. 2. Does the sway bar need to be mocked up (installed) to get alignment between each side, or is the alignment forgiving enough to eyeball? Thank you https://www.pelicanparts.com/techarticles/9...4_rear_sway.htm Hope this helps. (IMG:style_emoticons/default/smile.gif) |
| bkrantz |
Nov 15 2026, 07:33 PM
Post
#3
|
|
914 Guru ![]() ![]() ![]() ![]() ![]() Group: Members Posts: 8,819 Joined: 3-August 19 From: SW Colorado Member No.: 23,343 Region Association: Rocky Mountains
|
I reinforced the inside of the rear floor panel above the location for the bracket.
Attached thumbnail(s) |
| bkrantz |
Nov 15 2026, 07:38 PM
Post
#4
|
|
914 Guru ![]() ![]() ![]() ![]() ![]() Group: Members Posts: 8,819 Joined: 3-August 19 From: SW Colorado Member No.: 23,343 Region Association: Rocky Mountains
|
Here is a shot from underneath. When I cut out the rear floor I left the brackets attached to the cross member.
Attached thumbnail(s) |
![]() ![]() |
|
Lo-Fi Version | Time is now: 15th November 2026 - 07:49 PM |
| All rights reserved 914World.com © since 2002 |
|
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |