Home  |  Forums  |  914 Info  |  Blogs
 
914World.com - The fastest growing online 914 community!
 
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.
 

Welcome Guest ( Log In | Register )

> My djet fuel pressure testing results.
Bleyseng
post Apr 24 2007, 07:14 PM
Post #1


Aircooled Baby!
**********

Group: Members
Posts: 13,035
Joined: 27-December 02
From: Seattle, Washington (for now)
Member No.: 24
Region Association: Pacific Northwest



on my car at 29-30lbs of fuel @ 3000 rpms cruising the AFR is 13.7 to 1.
bump up the fuel pressure to 35-36 lbs @ the same speed the AFR is .....13.1 to 1.

So in this case it don't adjust it that much but for fine tuning its fine. It seemed to change it across the board including WOT that much.

These are just cleaned and tested 2.0L injectors too.
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
 
Reply to this topicStart new topic
Replies(1 - 2)
jk76.914
post Apr 24 2007, 07:56 PM
Post #2


Senior Member
***

Group: Members
Posts: 809
Joined: 12-April 05
From: Massachusetts
Member No.: 3,925
Region Association: North East States



Hey Geoff, That's great data. I've always wondered about that. Have you ever tried a pressure regulator that modulates fuel pressure with engine vacuum? Seems to me that it may help some of the part throttle cruise lean misfires that some of us see, if it's set up thoughtfully.

Jim
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
Bleyseng
post Apr 24 2007, 09:55 PM
Post #3


Aircooled Baby!
**********

Group: Members
Posts: 13,035
Joined: 27-December 02
From: Seattle, Washington (for now)
Member No.: 24
Region Association: Pacific Northwest



I guess I could try one off a ljet setup to see but you shouldn't be having a lean miss.

you could have a MPS thats slightly lean in spec.. the factory ones I have tested are all over the place.
this is why I have said for 10 years now the "Best" way is to pull the WOT stop and tune the sucker on a dyno to get the right AFR under load conditions. You then adjust it to be close thru out the rpm range as the AFR will be like a wave and not flat. You adjust for the best average!

Using a LM1 under driving conditions works great too but its a headache. I need to setup a harness extension so I can have the MPS in the cabin. (IMG:style_emoticons/default/chair.gif)
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



- Lo-Fi Version Time is now: 9th June 2024 - 01:43 AM