axle and CV compatabilty between a 914 & 912 question |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
axle and CV compatabilty between a 914 & 912 question |
sbonthemesa |
Nov 2 2008, 02:29 PM
Post
#1
|
Semi-Lurker Group: Members Posts: 35 Joined: 30-September 05 From: the mesa Member No.: 4,895 Region Association: None |
I have access to a set of good 912 axle and CV assemblies. Early, not the 76E.
Will they fit? Not a big deal if I have to re-drill the CVs. I'm more concerned with width between the trans and stub axles. This post has been edited by sbonthemesa: Nov 2 2008, 02:30 PM |
davep |
Nov 2 2008, 06:07 PM
Post
#2
|
914 Historian Group: Benefactors Posts: 5,151 Joined: 13-October 03 From: Burford, ON, N0E 1A0 Member No.: 1,244 Region Association: Canada |
The 911 / 912 shafts are shorter than the 914. In most cases the early 912 is not a good source of parts. A 1969 912 might stand a chance, but the SWB version I'd say little chance.
|
Lo-Fi Version | Time is now: 2nd June 2024 - 11:07 AM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |