Home  |  Forums  |  914 Info  |  Blogs
 
914World.com - The fastest growing online 914 community!
 
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.
 

Welcome Guest ( Log In | Register )

> A quick question, Do 1.8 heads have a port for a CHT sensor?
JamesM
post Apr 20 2009, 01:05 PM
Post #1


Advanced Member
****

Group: Members
Posts: 2,111
Joined: 6-April 06
From: Kearns, UT
Member No.: 5,834
Region Association: Intermountain Region



Do 1.8 heads have a port for a CHT sensor? If not, is there a place to easily add one?

All my cars have been 1.7's and 2.0's so i have never had a good look at a 1.8 head up close.


Thanks

-James
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
 
Reply to this topicStart new topic
Replies(1 - 3)
Cevan
post Apr 20 2009, 01:24 PM
Post #2


Senior Member
***

Group: Members
Posts: 1,079
Joined: 11-December 06
From: Western Massachusetts
Member No.: 7,351



Both my '74 and '75 1.8 motors had CHT sensors in the head next to #3 plug.
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
JamesM
post Apr 20 2009, 01:55 PM
Post #3


Advanced Member
****

Group: Members
Posts: 2,111
Joined: 6-April 06
From: Kearns, UT
Member No.: 5,834
Region Association: Intermountain Region



Thanks


I am in the planning stages of helping someone convert their carbed 1.8 to megasquirt and needed to know if the port was there as i am planning on using a 1.7 djet setup as a base. I just have not been able to see the car yet myself.




QUOTE(Cevan @ Apr 20 2009, 11:24 AM) *

Both my '74 and '75 1.8 motors had CHT sensors in the head next to #3 plug.

User is offlineProfile CardPM
Go to the top of the page
+Quote Post
Cap'n Krusty
post Apr 20 2009, 02:13 PM
Post #4


Cap'n Krusty
**********

Group: Members
Posts: 10,794
Joined: 24-June 04
From: Santa Maria, CA
Member No.: 2,246
Region Association: Central California



Even if the hole isn't there, the casting boss is there on all T4 heads. As long as you can drill the hole straight (and at a right angle to the surface), you can install a CHT sensor on any T4 head. Busses use one of the holes for the screw that holds the tin in place, right next to the intake manifold). The Cap'n
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



- Lo-Fi Version Time is now: 31st July 2025 - 03:41 PM