I moved my entire gearshift up, A CSOB's solution Options

[URY914]

In case you missed this, I thought I'd share it with you...

In an attempt to be able to perform quicker gear shifts, I have raised my gearshift base and shift rod about 3" above the stock location. This means that the forward shift rod is above the center tunnel but still uses the stock firewall bushing. I figure if I move the gearshift closer to the steering wheel my hand will spend less time going between the wheel and the gearshift.

I did not add universal joints to the shift rod. The coupling under the gearshift and at the firewall allows for some degree of mis-alinement. I fabricated the brackets so I could adjust them so if the mis-alinement was too great and the rod was binding up I could back it down and free it up.

If I really wanted to raise it up 6" or so I'd have to add u-joints into the rod. Than I could also cut a few inches off the gear shift handle to reduce the throw. Maybe I'll do this next if this doesnt work out completely.

This is not a pretty polished custom CNC fabricated aluminum piece but it works. I have not driven the car with it, but it is little more stiff that stock. I only use 1-2-3 anyway so I'll learn to live with it.

[rhodyguy]

the new fw shift bushings are crap anymore it seems. aside from missing paint from wear off, my forward rod is in good shape and it was sloppier than i expected with a new bushing. if the bushing pictured had a spherical center it would be extra swell. the bolt points won't fit in the outside of the stock ss disc/cover the boot goes on. outside mounting might interfear with the coupler. an inside fw install would be the way to go.

love the shifter paul.

k