 My teener won't fire., Just re did the fuel pump wireing. |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Eric Taylor |
 Dec 31 2003, 07:15 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 909 Joined: 1-June 03 From: Newport, OR/Eugene Oregon- UO Member No.: 770  |
So, today while trying to figure out my fuel problem I noticed that my fuel pump was running off of the coil, and batt ground. I've been told that the coil should not have to push any other devices, so I decieded to wire it back to the stock wireing. Well that went smoothly and now my pump primes for 2 second's and shut's off , YA!, but the car won't fire. I know it's the new wireing because it did fire when running off of the coil. It seams to me that if I'm hearing it prime that would mean that it is getting 12 volt's. So does this mean I have a bad relay?
Eric |
   |
 
|
  |
Replies
| rhodyguy |
Jan 1 2004, 11:19 AM
Post
#2
|
|
Chimp Sanctuary NW. Check it out. Group: Members Posts: 22,249 Joined: 2-March 03 From: Orion's Bell. The BELL! Member No.: 378 Region Association: Galt's Gulch |
imho you want the pump to run when you turn the key to the on position with carbs.
kevin |
|
|
|
Posts in this topic
Eric Taylor My teener won't fire. Dec 31 2003, 07:15 PM
redshift So there was a hardwire to the + side of the coil.... Jan 1 2004, 02:20 AM Brad Roberts Check the fuse on the relay board for the fuel pum... Jan 1 2004, 02:37 AM 3d914 Eric,
Another thing to check is on the relay boar... Jan 1 2004, 10:36 AM Eric Taylor Alright, so tried the test relay idea, and it work... Jan 1 2004, 04:28 PM Brad Roberts Ok. This tell me three things:
1. the ground is g... Jan 1 2004, 05:03 PM Eric Taylor Hummm. I just put in the old coil wireing and it s... Jan 1 2004, 07:25 PM trojanhorsepower This is a dumb question, but have you double check... Jan 1 2004, 09:11 PM Brad Roberts Good point. You may have removed the coil pos. whe... Jan 1 2004, 09:15 PM Eric Taylor Found it! :trophy: Everything was fine with t... Jan 2 2004, 03:42 PM Brad Roberts Everyone needs a Bowlsby harness they just dont kn... Jan 2 2004, 03:57 PM
Eric Taylor lol, this is a bowlsby harness :) It's a great... Jan 2 2004, 04:02 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 11th July 2025 - 04:57 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.