 Brazing: How do you get rid of it?, on the trunk pivot... |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| swood |
 Jan 2 2004, 04:51 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,839 Joined: 6-February 03 From: Strong Beach Member No.: 251 Region Association: None  |
I'm having a tough time removing the pivots. How do you get rid of the brazing? I found more of it used in the trunk to fill a small rust hole.
I don't want to grind too much in case I cut through the sheet metal, and the grinder wheel (4.5") is too big to get the rear side. Suggestions? Attached image(s) 
|
   |
 
|
  |
Replies
| RON S. |
Jan 3 2004, 01:45 PM
Post
#2
|
|
9140430841, FINALLY RUNNING Group: Members Posts: 1,212 Joined: 22-May 03 From: WALTERBORO,S.C. Member No.: 724 Region Association: South East States |
I've
Heated it w/a torch till it just begins to flow. Have your air compressor cranked up to 100lbs of pressure,and as it begins to flow,hit w/air from a good blow gun. It's worked for me in the past. Ron |
|
|
|
Posts in this topic
swood Brazing: How do you get rid of it? Jan 2 2004, 04:51 PM
Mueller If you don't want to grind, you'll have to... Jan 2 2004, 06:14 PM 2-OH! I used a Dremel Tool with a Flex shaft and ginding... Jan 2 2004, 08:54 PM Carrera916 If you have access to acetylene-oxygen torch or MA... Jan 2 2004, 11:32 PM swood Yes it helps, thanks for the enlightening. Just a... Jan 3 2004, 10:18 AM Carrera916 Yeah...it sure is a drag to mess around with anyth... Jan 3 2004, 11:56 AM swood Theres really not that much of it to go to all tha... Jan 3 2004, 12:00 PM Mueller The MAP gas will work, I had to repair my 2.0 inta... Jan 3 2004, 12:01 PM
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 7th June 2024 - 04:42 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.