 disaster strikes?, valves too tight? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| mattp |
 Jul 3 2008, 09:34 PM
Post
#1
|
|
Member  Group: Members Posts: 257 Joined: 22-November 06 From: westchester NY Member No.: 7,252  |
I did my initial start up of my new raby engine, two of the cylinders had valves that were too tight causeing blow back throught the carbs. Adjusted valves and cant seem to make them any looser? any ideas?
also major oil leak from somewhere where engine meets transmission, thinking rear main seal?? |
   |
 
|
  |
Replies
| justme |
Jul 5 2008, 09:38 AM
Post
#2
|
|
Member Group: Members Posts: 189 Joined: 1-January 07 From: southampton ma atlantic northeast Member No.: 7,413 Region Association: North East States |
Like Jake said,
Try pulling the rockers and checking the pushrods. If your backed off the adjusters and have no slack either your not a TDC or pushrods are not seated. Did you do a trial assembly? Any problems should have surfaced then,no?? GOOD LUCK!! (IMG:style_emoticons/default/beer3.gif) |
|
|
|
Posts in this topic
mattp disaster strikes? Jul 3 2008, 09:34 PM
LowGT
I did my initial start up of my new raby engine, ... Jul 3 2008, 09:59 PM Borderline Who did the valve train setup and how were the pus... Jul 3 2008, 10:14 PM mattp I had Raby do the pushrods before sending kit. I u... Jul 4 2008, 08:25 AM HAM Inc Just to expand on what Bill said - When the #1 ex ... Jul 4 2008, 08:35 AM Jake Raby Matt's rocker geometry was completed by us dur... Jul 4 2008, 10:35 AM mattp I cant turn the adjuster any further. I backed it ... Jul 4 2008, 12:11 PM SGB Argghh. I feel your pain, bro. Dunno with the se... Jul 4 2008, 02:25 PM Jake Raby He didn't need a trial assembly... We did that... Jul 5 2008, 10:54 AM Borderline Were any shims left out? Cylinder or rocker shaft... Jul 5 2008, 11:02 AM
Jake Raby When Matt and I talked yesterday I asked him all t... Jul 5 2008, 11:39 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st August 2025 - 05:00 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.