 2.0 Head CC, Stock Volume? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Todd Enlund |
 Jul 21 2008, 05:31 PM
Post
#1
|
|
Resident Photoshop Guru  Group: Members Posts: 3,251 Joined: 24-August 07 From: Laurelhurst (Portland), Oregon Member No.: 8,032 Region Association: Pacific Northwest  |
I just CCed one of my heads. I got 62cc in both chambers. I thought that stock was 60cc? Does this mean that the buret that I bought is a POS?
By my math, 62cc chambers would give me 9.2:1 with a .040 deck height on a 96x78 mm 2258cc engine... 60cc would give me 9.4:1. Heads need a rebuild... I'm just trying to figure out where I'm at for a starting point. |
   |
 
|
  |
Replies
| r_towle |
Jul 21 2008, 07:30 PM
Post
#2
|
|
Custom Member Group: Members Posts: 24,585 Joined: 9-January 03 From: Taxachusetts Member No.: 124 Region Association: North East States 
|
I used tranny fluid...easy to see.
Dunno, but I think there was alot of variation from one set to another. Go for what you want...you can always get the head cut to reduce the chamber and then use base shims to get what you want... Rich |
|
|
|
Posts in this topic
Todd Enlund 2.0 Head CC Jul 21 2008, 05:31 PM
r_towle Its quite possible that you have a broken calculat... Jul 21 2008, 05:43 PM
Todd Enlund
Its quite possible that you have a broken calcula... Jul 21 2008, 05:48 PM r_towle I will assume that you put in the plug, held the p... Jul 21 2008, 05:54 PM Todd Enlund
I will assume that you put in the plug, held the ... Jul 21 2008, 07:15 PM 914Sixer Factory Tech Spec book says 58.7-60.2cc. My heads... Jul 21 2008, 07:14 PM Todd Enlund
I used tranny fluid...easy to see.
Dunno, but I t... Jul 21 2008, 07:55 PM Todd Enlund
I used tranny fluid...easy to see.
Dunno, but I ... Jul 21 2008, 08:27 PM Dominic
I just CCed one of my heads. I got 62cc in both ... Jul 21 2008, 08:45 PM Todd Enlund
The stroke on the 78mm crank is actually 78.4 mm ... Jul 25 2008, 04:27 PM HAM Inc The largest O.E. chamber I can recall measuring ca... Jul 22 2008, 07:59 AM Todd Enlund
The largest O.E. chamber I can recall measuring c... Jul 22 2008, 11:09 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st June 2024 - 06:01 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.