 CHT Temp, What is the upper operating limit? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| ericread |
 Oct 11 2008, 08:15 PM
Post
#1
|
|
The Viper Blue 914  Group: Members Posts: 2,177 Joined: 7-December 07 From: Irvine, CA (The OC) Member No.: 8,432 Region Association: Southern California  |
Based on the converstaions here,I drove over to Corona, CA (Aircraft Spruce) this afternoon and purchased the Micro 1000 CHT, a sensor and a 15 foot extension cable. It's all installed and looks great in my original center console.
So where is the danger point? Some posts say that hitting 400 degrees will cause a valve seat to fail. Others say they regularly see 375 to 400 degrees on their longer, higher speed drives. Where is the point that indicated engine heat danger? BTW: 74 2.0L all original FI w, standard exhaust. My thanks. Eric Read NOTE: Please note that this was originally posted in a CHT topic post. After about a day, I received no responses, so I am re-posting it as a unique topic. Cross-Posting Disclosure: Cross-posted to the "other" BBS (Saturday, 10/11/08) as a result of no response on this BBS. |
   |
 
|
  |
Replies
| davep |
Oct 11 2008, 08:49 PM
Post
#2
|
|
914 Historian Group: Benefactors Posts: 5,300 Joined: 13-October 03 From: Burford, ON, N0E 1A0 Member No.: 1,244 Region Association: Canada  |
About all I can recall at the moment is Len saying he uses a 400 degree oven to allow the valve seats to drop out of the heads. Based on that I'd say 350 is a decent limit.
|
 |
|
Posts in this topic
ericread CHT Temp Oct 11 2008, 08:15 PM
ericread By the way: The cost for the gauge, sensor and ext... Oct 11 2008, 08:24 PM 7275914911 There is a good info on CH temps in the Tech Artic... Oct 11 2008, 10:03 PM
ericread
There is a good info on CH temps in the Tech Arti... Oct 12 2008, 12:02 AM toon1 your good! :D
Those temps fall well within... Oct 11 2008, 10:56 PM r_towle If you take a head and put it in the oven with th... Oct 12 2008, 07:40 AM toon1
If you take a head and put it in the oven with t... Oct 12 2008, 09:22 AM Jake Raby Sensor location is key! You must install the s... Oct 12 2008, 06:22 PM ericread
Sensor location is key! You must install the ... Oct 12 2008, 07:07 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st August 2025 - 04:30 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.