 Changing motor mounts. DONE! |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| LeNoah |
 Oct 11 2008, 12:11 PM
Post
#1
|
|
Newbie  Group: Members Posts: 35 Joined: 5-September 08 From: the OC Member No.: 9,515 Region Association: Southern California  |
Hey gang,
Lookin' for a "how-to", tutorial or just some veterans advice on installing new motor mounts on my '74 2.0. It appears to be fairly straight forward but never having done it before I know there are always "catches" and thing s to look for. Any advice before I get into this would be greatly appreciated. Thanks, LN |
   |
 
|
  |
Replies
| Jax914 |
Oct 12 2008, 02:19 PM
Post
#2
|
|
Schwienhund Rennenmannshaft Group: Members Posts: 138 Joined: 7-August 06 From: Jacksonville, FL Member No.: 6,602 Region Association: South East States |
Having just replaced both mounts with the poly ones and the solid bolt - the biggest pain I had was trying to undo those top bolts with nothing to hang on to - the rubber was completely twisted off.
My top nuts were 13mm. A short socket worked the best... |
|
|
|
Posts in this topic
LeNoah Changing motor mounts. DONE! Oct 11 2008, 12:11 PM
LeNoah Anybody? Can you direct me to an article?. Haynes ... Oct 11 2008, 01:33 PM LeNoah Planning on tackling this tonight. Hoping for a li... Oct 11 2008, 04:25 PM LeNoah What!?!? Nobody wants to give advice? What... Oct 12 2008, 10:16 AM
bdstone914
What!?!? Nobody wants to give advice? Wha... Oct 12 2008, 11:34 AM McMark Use a jack/jackstands to support the motor, then r... Oct 12 2008, 11:37 AM LeNoah Is that elusive top nut 13mm? Ratcheting wrench so... Oct 12 2008, 12:09 PM Dave_Darling I think the top nut is 10mm. The hole in the brac... Oct 12 2008, 01:49 PM Brando I've had to do a few and the quickest way is w... Oct 12 2008, 03:00 PM SLITS I could get a 1/4" rachet in there and have d... Oct 12 2008, 03:38 PM LeNoah Thanks for all the tips guys. Its always good to s... Oct 12 2008, 04:20 PM tommy914 I remember this being very difficult. I must not ... Oct 12 2008, 11:55 PM LeNoah What a biatch!!!! Never wanna do t... Oct 13 2008, 10:07 PM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 11th May 2025 - 05:52 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.