 my oil/ engine problems diagnosis ?, updated, Just did compression test today 3/17/09 |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| jsayre914 |
 Mar 3 2009, 04:52 PM
Post
#1
|
|
Speed Up !!!  Group: Members Posts: 3,210 Joined: 10-February 08 From: Timonium MD 21093 Member No.: 8,696 Region Association: MidAtlantic Region  |
take a look guys, by the way I did get her home the other night, and i beat the snow.
Attached image(s)     
|
   |
 
|
  |
Replies
| VaccaRabite |
Mar 3 2009, 08:10 PM
Post
#2
|
|
En Garde! Group: Admin Posts: 13,755 Joined: 15-December 03 From: Dallastown, PA Member No.: 1,435 Region Association: MidAtlantic Region 
|
Hey Joe,
I'm not in class this week. Next week I have Monday off, but it gets insane again for me right after that. If it is sucky outside, we can warm up your engine by running it in the garage with a hose hooked up to the exhaust pipe. If your valves have not been done in a while, I'll bring feeler gauges too. If it comes to it that you need to rebuild, all my resources are at your disposal. If you get good numbers, we can look and see if there is something else funky. I won't lie. I want to help you rebuild your engine. I've got all this crap now, and I want to use it. Zach |
|
|
|
Posts in this topic
jsayre914 my oil/ engine problems diagnosis ? Mar 3 2009, 04:52 PM
jsayre914 more Mar 3 2009, 04:54 PM jsayre914 ... Mar 3 2009, 04:56 PM jsayre914 last ones Mar 3 2009, 04:57 PM jsayre914 Zach said he would loan me a compression tester, i... Mar 3 2009, 04:58 PM yeahmag Been a while since I had FI on the car. Could you ... Mar 3 2009, 06:51 PM
jsayre914
Could you tell if it was coming from one of the b... Mar 3 2009, 09:22 PM Jake Raby Tons of blow by... Either the rings are shot or th... Mar 3 2009, 06:54 PM type47 Good thing a response I made didn't get posted... Mar 3 2009, 07:09 PM yeahmag When combustion gases go flying past the rings the... Mar 3 2009, 07:21 PM Jake Raby Bad rings can create blowby as they allow gases to... Mar 3 2009, 07:28 PM jsayre914
Bad rings can create blowby as they allow gases t... Mar 3 2009, 09:24 PM r_towle
Bad rings can create blowby as they allow gases ... Mar 3 2009, 09:33 PM Dr Evil So, when are we going to rebuild your engine :) :i... Mar 3 2009, 07:54 PM wertygrog My engine does the same thing when a hose falls of... Mar 3 2009, 08:06 PM championgt1 How did your engine run before this mess? The stac... Mar 3 2009, 08:15 PM jsayre914
How did your engine run before this mess? The sta... Mar 3 2009, 09:28 PM r_towle
How did your engine run before this mess? The st... Mar 3 2009, 09:34 PM jsayre914 anyone know where this came from?? Mar 3 2009, 09:33 PM r_towle oh, the oil is from your Head vent hoses and the l... Mar 3 2009, 09:34 PM Vacca Rabite
oh, the oil is from your Head vent hoses and the ... Mar 4 2009, 08:46 AM Vacca Rabite by the way, if it is bad rings...
the only constr... Mar 4 2009, 08:53 AM 904svo Way off the deep end, but did you check the oil pr... Mar 4 2009, 01:25 PM jsayre914
Way off the deep end, but did you check the oil p... Mar 4 2009, 01:50 PM type47
Way off the deep end, but did you check the oil ... Mar 4 2009, 02:35 PM yeahmag The switch would not pump oil in to the air cleane... Mar 4 2009, 02:23 PM jsayre914 I just finished the compression test..... drumroll... Mar 17 2009, 01:04 PM Dr Evil Well, since the two on the samer side, 1 and 2, ar... Mar 17 2009, 01:51 PM jsayre914
Well, since the two on the samer side, 1 and 2, a... Mar 17 2009, 02:41 PM Drums66 The AAR valve you are using the 4th photo
is comm... Mar 17 2009, 02:45 PM yeahmag The combination of oil in the air cleaner and low ... Mar 17 2009, 03:43 PM Dr Evil Ah ya, if you are getting oil in your filter you a... Mar 17 2009, 03:56 PM yeahmag I would think it unwise to do just the 1-2 side. I... Mar 17 2009, 04:00 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 6th July 2025 - 12:55 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.