Welding question |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Welding question |
PeeGreen 914 |
Mar 22 2009, 10:17 PM
Post
#1
|
Just when you think you're done...wait, there is more..lol Group: Members Posts: 10,219 Joined: 21-September 06 From: Seattle, WA... actually Everett Member No.: 6,884 Region Association: Pacific Northwest |
So I am welding in the Tangerine Racing inner consol reinforcement. If I have the welder set on three it doesn't bite into the ear. If I have it set on four it bites but it blows holes in the new piece. I was able to get two holes filled and they are definitely welded on. However, I am wanting to know before I do more if going on the four setting will be right and not damage anything. Three just doesn't seem to cut it.
|
jmill |
Mar 23 2009, 10:18 AM
Post
#2
|
Green Hornet Group: Members Posts: 2,449 Joined: 9-May 08 From: Racine, Wisconsin Member No.: 9,038 Region Association: Upper MidWest |
I'm with Panelbilly on this one.
If it's too hot you increase the feed and move faster. If it's too cold you decrease the feed and move slower. The idea is to keep a good arc without burning through. It should sound like frying bacon not snap crackle and pop. You get no penetration on the high amp setting and low feed because you can't keep an arc. The high amp arc burns the wire back to the tip before it gets to the metal. It's a great way to burn up a tip. |
Lo-Fi Version | Time is now: 7th June 2024 - 12:02 AM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |