23mm MC plumbing question |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
23mm MC plumbing question |
Qarl |
Jan 30 2004, 11:34 PM
Post
#21
|
Shriveled member Group: Benefactors Posts: 5,233 Joined: 8-February 03 From: Florida Member No.: 271 Region Association: None |
I will be installing a 23mm MC to feed the bigger brakes on the new car. I have heard that their are plumbing issues, and clearance issues when installing the bigger MC.
I'm looking for feedback from those that have done this. Here is a comparison of the new and old MC. I have some questions. 1) Ports 3 and 4 are the front and rear output ports. These correspond (location-wise) to ports 1 and two on the new MC. It seems that I can just transfer the hardware and lines over without any issues. Correct? 2) The locations of the feed lines are different between new and old. Is this going to be a clearance issue? 3) The hydraulic pressure switch (located between ports 3 and 4) does not have a corresponding location on the NEW MC. But there is another output port on the bottom of the MC (underneath port 1) that I can use? Any clearance issus here? 4) Does anyone know what the bolt on the top of the NEW MC is for? (between the red caps)... If I remove it, will a genie come out and grant me 3 wishes? These would be easier to answer if my car body were in the same location as my parts. (hopefully in a couple of weeks!) Thanks! Attached image(s) |
ArtechnikA |
Jan 31 2004, 07:47 AM
Post
#22
|
rich herzog Group: Members Posts: 7,390 Joined: 4-April 03 From: Salted Roads, PA Member No.: 513 Region Association: None |
QUOTE(0396 @ Jan 31 2004, 05:07 AM) I believe one has to use the alloy cross member to make this work. i've heard this too, but i can tell you from personal experience i did it with a standard OEM 914.6 steel (911) crossmember. 914.4 uses the 914.341.013.03 auxiliary support; 914.6 uses the 901.341.013.03 auxiliary support. you'd think there's be SOME difference or there wouldn't be two part numbers. i've never tried to put a 23mm MC in a /4 but it goes in a /6 just fine. you probably need a 911 crossmember - alloy or not... |
Lo-Fi Version | Time is now: 10th June 2024 - 04:27 AM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |