 Cylinder honing, Anyone done it at home? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| r_towle |
 May 3 2009, 08:15 PM
Post
#1
|
|
Custom Member  Group: Members Posts: 24,705 Joined: 9-January 03 From: Taxachusetts Member No.: 124 Region Association: North East States 
 |
Using a dingle berry hone tool
Rich |
   |
 
|
  |
Replies
| sean_v8_914 |
May 4 2009, 11:32 PM
Post
#2
|
|
Chingon 601 Group: Members Posts: 4,011 Joined: 1-February 05 From: San Diego Member No.: 3,541 |
ball hone is fine for a home re-ring. remove ALL teh carbon ridge first. if they dont clean up in 15 sec, they will need a real hone job as capt described
|
|
|
|
Posts in this topic
r_towle Cylinder honing May 3 2009, 08:15 PM
dbgriffith75 I'm not sure what you mean by "dingle ber... May 3 2009, 08:28 PM 76-914 Not in years but, yea. Does your existing cylider ... May 3 2009, 08:41 PM r_towle Why the rag?
What is the purpose?
Rich May 3 2009, 10:05 PM Cap'n Krusty IME, and in the opinion of most good machinists I... May 3 2009, 10:26 PM craig downs I strongly agree with the cap'n a ball hone is... May 3 2009, 10:52 PM charliew I have used a ball type hone on many normal re-rin... May 4 2009, 02:42 PM
r_towle
I have used a ball type hone on many normal re-ri... May 4 2009, 04:23 PM Cap'n Krusty Remember, proper honing of air cooled cylinders is... May 4 2009, 06:54 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 17th July 2025 - 06:33 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.