 Rotor turning question |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| 914werke |
 May 16 2009, 10:24 AM
Post
#1
|
|
"I got blisters on me fingers"  Group: Members Posts: 10,120 Joined: 22-March 03 From: USofA Member No.: 453 Region Association: Pacific Northwest 
 |
How much material is "typically" taken down on a rotor
when turning them ? Outside of unusual run-out or grooving. (IMG:style_emoticons/default/bye1.gif) |
   |
 
|
  |
Replies
| aircooledtechguy |
May 16 2009, 10:57 AM
Post
#2
|
|
The Aircooledtech Guy Group: Members Posts: 1,966 Joined: 8-November 08 From: Anacortes, WA Member No.: 9,730 Region Association: Pacific Northwest |
My machinist only removes as much from each side as required to get a completely clean groove-free surface. So it depends on how deep the grooving or warps are on the rotor being turned and how deep the grooves are. there's no real set amount; only a minimum thickness for the disk post turned. . .
|
|
|
|
Posts in this topic
rdauenhauer Rotor turning question May 16 2009, 10:24 AM
McMark :agree: May 16 2009, 11:55 AM
ConeDodger :agree: with the above but...
For cars used in pe... May 16 2009, 12:04 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 3rd June 2024 - 07:40 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.