 Is there a bushing in shift linkeage of 72 1.7 ? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| orange73 |
 Jun 9 2009, 01:39 PM
Post
#1
|
|
orange 72  Group: Members Posts: 14 Joined: 11-May 09 From: Homer Glen IL. Member No.: 10,355 Region Association: Upper MidWest  |
I have a 72 914 with 1.7 eng. It has the long shift rod that goes all the way to back of engine / trans . The previous owner has placed about 4 heavey duty wire ties around this junction and I assume they are taking the place of some type of bushing that may be missing ?? Is there a bushing that goes here ? Is it hard to replace ? It shifts ok , a little sloppy but I am sure it will improve if I can get what is supposed to be there replaced. Any help is appreciated. Thanks
|
   |
 
|
  |
Replies
| tat2dphreak |
Jun 9 2009, 01:55 PM
Post
#2
|
|
stoya, stoya, stoya Group: Benefactors Posts: 8,797 Joined: 6-June 03 From: Wylie, TX Member No.: 792 Region Association: Southwest Region  |
Tail shift linkage
and Tail shift adjustment those links should help you out a lot, I'm not sure where you mean.. if you have a tail-shift, I would watch for a cheap side-shift to upgrade... you'll need the tranny, all linkage, the engine bar, and the outer engine bar mounts. |
|
|
|
Posts in this topic
orange73 Is there a bushing in shift linkeage of 72 1.7 ? Jun 9 2009, 01:39 PM
Project 6 Are the covers for the shift rod end still availab... Jun 9 2009, 03:44 PM
McMark The stock 72 setup has a whole mess of bushings th... Jun 9 2009, 03:49 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd April 2026 - 11:30 AM |
Invision Power Board
v9.1.4 © 2026 IPS, Inc.