Home  |  Forums  |  914 Info  |  Blogs
 
914World.com - The fastest growing online 914 community!
 
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.
 

Welcome Guest ( Log In | Register )

> what are these wires for?, left overs from the relay board
RJMII
post Jun 23 2009, 12:17 AM
Post #1


Jim McIntosh
****

Group: Members
Posts: 3,125
Joined: 11-September 07
From: Sandy, Utah
Member No.: 8,112
Region Association: None



The diagrams I was looking at were slightly vague about where these wires go...

they used to go to my relay board.

any help would be greatly appreciated.



Attached thumbnail(s)
Attached Image
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
 
Reply to this topicStart new topic
Replies
RJMII
post Jun 23 2009, 09:42 AM
Post #2


Jim McIntosh
****

Group: Members
Posts: 3,125
Joined: 11-September 07
From: Sandy, Utah
Member No.: 8,112
Region Association: None



Dave, that helps some. thank you. (what were you doing to your car? I think you picked out most of the same wires that I did?)

there are two for the back up lights? Do I wire these two straight to the transimssion?



User is offlineProfile CardPM
Go to the top of the page
+Quote Post
astronomerdave
post Jun 23 2009, 12:11 PM
Post #3


Member
**

Group: Members
Posts: 69
Joined: 26-January 09
From: Los Angeles, CA
Member No.: 9,979
Region Association: Southern California



QUOTE(RJMII @ Jun 23 2009, 08:42 AM) *

Dave, that helps some. thank you. (what were you doing to your car?

I removed the engine and installed an electric motor: click here for electric car link, and 3,4,5,7,8 were the only wires I needed off the relay board.

QUOTE(RJMII @ Jun 23 2009, 08:42 AM) *

there are two for the back up lights? Do I wire these two straight to the transimssion?

Well, as I removed the relay board, those two are now connected to my reverse light switch on the trans instead of running through the relay board.

Are you trying to re-assemble the relay board, or something more like what I did?
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



- Lo-Fi Version Time is now: 31st October 2024 - 05:01 PM