![]() |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
![]() |
Elliot Cannon |
![]()
Post
#1
|
914 Guru ![]() ![]() ![]() ![]() ![]() Group: Retired Members Posts: 8,487 Joined: 29-December 06 From: Paso Robles Ca. (Central coast) Member No.: 7,407 Region Association: None ![]() ![]() ![]() |
If there is positive pressure inside the cooling shroud, wouldn't these seal better if they where pushed inside the cooling shroud? I've always installed them on the outside. Do you?
Attached image(s) ![]() |
![]() ![]() |
VaccaRabite |
![]()
Post
#2
|
En Garde! ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Group: Admin Posts: 13,465 Joined: 15-December 03 From: Dallastown, PA Member No.: 1,435 Region Association: MidAtlantic Region ![]() |
I always put the bigger flap on the inside. I just thought it was supposed to go that way.
The #2 cylinder does not quite seal, but all the other seal way better then with the flap on the out side (the #2 seals better too, just not perfectly.) My plug wires only have the one big flap, not a smaller inside flap. My earlier set of wires did not have the smaller flap either... Zach |
![]() ![]() |
![]() |
Lo-Fi Version | Time is now: 16th June 2024 - 12:45 AM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |