 Spark plug gaskets, Inside the cooling shroud or out? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Elliot Cannon |
 Sep 22 2009, 09:57 PM
Post
#1
|
|
914 Guru  Group: Retired Members Posts: 8,487 Joined: 29-December 06 From: Paso Robles Ca. (Central coast) Member No.: 7,407 Region Association: None 
 |
If there is positive pressure inside the cooling shroud, wouldn't these seal better if they where pushed inside the cooling shroud? I've always installed them on the outside. Do you?
Attached image(s) 
|
   |
 
|
  |
Replies
| URY914 |
Sep 23 2009, 09:32 AM
Post
#2
|
|
I built the lightest 914 in the history of mankind. Group: Members Posts: 121,106 Joined: 3-February 03 From: Jacksonville, FL Member No.: 222 Region Association: None |
I was going to make some fiberglass covers that fit the sheetmetal real tight and have a hole for the wire to thread thru. They'd be held in place by a sheetmetal screw.
It's on my bucket list.... (IMG:style_emoticons/default/biggrin.gif) |
|
|
|
Posts in this topic
Elliot Cannon Spark plug gaskets Sep 22 2009, 09:57 PM
krazykonrad The bigger "flange" for lack of a better... Sep 22 2009, 10:07 PM McMark Hey, that's a good idea. :toof: Sep 22 2009, 10:08 PM Vacca Rabite I always put the bigger flap on the inside. I jus... Sep 23 2009, 09:18 AM 76-914 JMHO, but maybe that seal has another purpose? May... Sep 23 2009, 08:19 PM ArtechnikA ...Until they get brittle from the heat and then b... Sep 24 2009, 06:05 AM
Tom Another use for duck tape? Hee, heee. Just kiddi... Sep 24 2009, 01:08 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 15th June 2024 - 10:12 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.