|
|

|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| drumsticks2112 |
Sep 20 2009, 12:56 PM
Post
#1
|
|
Newbie ![]() Group: Members Posts: 7 Joined: 29-October 08 From: New London Member No.: 9,704 Region Association: Upper MidWest |
Car fires without a problem, but idles quite rough, and runs very rich, so much so that when the it settles down to normal idles, it floods out. MPS was replaced with a used but tested one recently. When it was last running ( a year ago) it ran a little rich, but nothing like this.
As of now, the CHT is not connected. When it is connected, the RPMs jump up to 4000 and stay there. When the CHT is bypassed with direct grounding of the harness, the results are the same as with the sensor being disconnected. I have no reason to suspect the injectors, FPR, Decel Valve, or the MPS. Any and all advice is welcome. -Todd |
![]() ![]() |
| CHAZT54 |
Sep 23 2009, 12:41 PM
Post
#2
|
|
CHAZT54 ![]() Group: Members Posts: 19 Joined: 29-December 08 From: New London, Wisconsin Member No.: 9,878 Region Association: Upper MidWest |
I am working with drumsticks on this car and have done the following in the last 24 hrs to track down the source of this problem;
I replaced the vac. hose going to the MPS - there seemed to be good vaccum on the MPS end of the hose when running and connecting it to the MPS while running had minimal effect- still flooding out. At the same time I connected the hd temp sensor lead to the inj. harness lead which makes the eng race immediately without moving the throttle body flap. ALSO - grounding the hd temp lead from the brain had NO effect. I am beginning to think we are barking up the wrong tree. This car ran pretty good a year ago, albeit a little rich, without the hd temp sensor being hooked up. In the process of restoring the car over the winter, we removed the throttle body and intake tubes for cleaning and painting and then re-assembled with new gaskets. No other EFI components were disturbed. The throttle valve sensor was recalibrated upon assembly. As stated before, the eng. fires right up but the plugs eventually drown in gasoline at idle. I have not yet checked the fuel pressure - possible source of the problem? We are frustrated and open to any and all advice. CHAZT54 |
drumsticks2112 74 2.0L, Running Very Rich, owner quite confused Sep 20 2009, 12:56 PM
type47 I thought the CHT had to be connected to run; must... Sep 20 2009, 04:12 PM
Rand Running that rich makes me suspect the MPS (even t... Sep 20 2009, 04:18 PM
Dave_Darling Disconnecting the CHT will send the mixture very r... Sep 20 2009, 04:53 PM
pilothyer I didn't think an open CHTS would allow the ca... Sep 20 2009, 05:15 PM
underthetire I had a CHT go bad. Went open when hot. Biatch to ... Sep 21 2009, 10:04 AM
greenie
I am working with drumsticks on this car and have... Sep 23 2009, 07:41 PM
Dave_Darling ...At the same time I connected the hd temp sensor... Sep 23 2009, 08:51 PM
tod914 Did you actually test the MPS to see if it holds v... Sep 23 2009, 07:56 PM
drumsticks2112
Did you actually test the MPS to see if it holds ... Sep 23 2009, 10:09 PM
Bleyseng does sound like a vacuum leak of misplaced hose to... Sep 23 2009, 10:07 PM
tod914 Compliments of Dave. http://www.pelicanparts.com/... Sep 23 2009, 10:26 PM
drumsticks2112
Compliments of Dave. http://www.pelicanparts.com... Sep 23 2009, 10:58 PM
CHAZT54
[quote name='tod914' post='1218012' date='Sep 23 ... Sep 30 2009, 12:47 PM
Van914 Did you check the adjustment on the FI Brain. I us... Sep 30 2009, 01:13 PM
rjames
Did you check the adjustment on the FI Brain. I u... Sep 30 2009, 01:36 PM
drumsticks2112 Thanks for the additional ideas guys, here is the ... Sep 30 2009, 04:22 PM
r_towle Start at the beginning.
Remove EVERY vacuum line f... Sep 30 2009, 03:39 PM
Rand Like Dave said, idle that fast means there HAS to ... Sep 30 2009, 03:39 PM
r_towle no idea what an FPS is nor a TVS.
The MPS does not... Sep 30 2009, 04:33 PM
drumsticks2112
no idea what an FPS is nor a TVS.
The MPS does no... Sep 30 2009, 09:57 PM
Dave_Darling The MPS has a mechanical component. If you shake ... Sep 30 2009, 11:11 PM
CHAZT54 OK - we took your advice and dismantled the intake... Oct 2 2009, 07:52 AM
r_towle There is no fuel pressure sensor...a fuel pressure... Oct 2 2009, 01:13 PM
CHAZT54
There is no fuel pressure sensor...a fuel pressur... Oct 2 2009, 03:42 PM
CHAZT54
There is no fuel pressure sensor...a fuel pressu... Oct 5 2009, 12:21 PM
r_towle
[quote name='CHAZT54' post='1221175' date='Oct 2 ... Oct 5 2009, 04:48 PM
CHAZT54
[quote name='CHAZT54' post='1221175' date='Oct 2... Oct 6 2009, 07:47 AM
r_towle
[quote name='r_towle' post='1222305' date='Oct 5 ... Oct 6 2009, 01:18 PM
r_towle You will need an inline gauge to confirm how the F... Oct 2 2009, 04:51 PM
Rand I just pulled the line off the CSV and plugged it.... Oct 6 2009, 10:52 AM
CHAZT54 EUREKA!!
It finally runs & idles norma... Oct 8 2009, 12:27 PM![]() ![]() |
|
Lo-Fi Version | Time is now: 2nd April 2026 - 11:14 AM |
| All rights reserved 914World.com © since 2002 |
|
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |