 Puckering Rubber - It' Won't Go Down! |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| bandjoey |
 Nov 13 2009, 11:00 PM
Post
#1
|
|
bandjoey  Group: Members Posts: 4,934 Joined: 26-September 07 From: Bedford Tx Member No.: 8,156 Region Association: Southwest Region  |
Installed an oem front hood weather strip and it's puckered up at the front and rear center, from being folded in the plastic bag. All the way around it won't lay flat, causing the hood to ride about 1/8" up above the fender line. It's been on the car for about a month.
How can I get my rubber to go down and lay flat. (IMG:style_emoticons/default/blink.gif) Attached thumbnail(s)   
|
   |
 
|
  |
Replies
| Soul |
Nov 15 2009, 02:34 PM
Post
#2
|
|
Newbie Group: Members Posts: 15 Joined: 2-November 09 From: Cal-Lookafornia Member No.: 11,003 Region Association: Southern California |
With my VW's, this was a common problem which usually meant the rubber is stretched too tight in another area.
As Sean suggested, push from the middle to the corners and try to evenly distribute the seal. |
|
|
|
Posts in this topic
bandjoey Puckering Rubber - It' Won't Go Down! Nov 13 2009, 11:00 PM
Grelber Maybe a LITTLE heat, say from a hair dryer? Nov 14 2009, 07:44 AM bandjoey Hair Dryer and then Heat Gun..neither worked. How... Nov 14 2009, 06:18 PM tod914 Maybe take the seal out. Lay it out flat like it ... Nov 14 2009, 07:21 PM Gint I put the front trunk seal on my /6 trunk a couple... Nov 14 2009, 07:27 PM Sleepin If it doesn't go down in four hours, you shoul... Nov 14 2009, 07:44 PM sean_v8_914 I see a bent/deformed seal track. I also see pre-l... Nov 15 2009, 02:21 PM charliew If you are sure it's from being folded then ma... Nov 15 2009, 07:15 PM bandjoey Yep. It was folded in half at the top and bottom ... Nov 15 2009, 09:24 PM sean_v8_914 you could try chemical persuasion Nov 15 2009, 09:57 PM
bandjoey U mean like a little laquer thinner or carb cleane... Nov 15 2009, 10:02 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 3rd July 2025 - 01:42 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.