 FI Trigger Points Install, How to do it? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Eric Taylor |
 Feb 22 2004, 04:16 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 909 Joined: 1-June 03 From: Newport, OR/Eugene Oregon- UO Member No.: 770  |
What's the best way of installing the trigger points for the injectors? Do I need to remove the distro?
Thanks, Eric |
   |
 
|
  |
Replies
| Dave_Darling |
Feb 22 2004, 05:27 PM
Post
#2
|
|
914 Idiot Group: Members Posts: 14,991 Joined: 9-January 03 From: Silicon Valley / Kailua-Kona Member No.: 121 Region Association: Northern California 
|
You will need to re-set the timing. You'll get pretty close if you turn the distributor until the idle RPM is the same as it was before you started.
You might be able to work around the vacuum dashpot, but chances are pretty good that it'll be easier to remove the mounting screws for it so you can get it out of the way. Use the Bosch distributor lube on the cam for the trigger points. One tube is a lifetime supply for about six 914 owners, so see if someone in your area already has a tube of it. --DD |
|
|
|
Posts in this topic
Eric Taylor FI Trigger Points Install Feb 22 2004, 04:16 PM
type47 really, you do, unless you are a contorsionist. im... Feb 22 2004, 04:21 PM McMark Yes, remove the dizzy. Make sure to unbolt the cl... Feb 22 2004, 04:53 PM Eric Taylor I did a test dizzy removal on the 2.0 wreck and it... Feb 22 2004, 05:16 PM Eric Taylor So it is ok to pull it like that? I was very afrai... Feb 22 2004, 05:29 PM ChrisReale Take the dizzy out. Inspect the gasket also. It ... Feb 22 2004, 05:45 PM ThinAir914 <... Feb 22 2004, 08:19 PM ThinAir914 I suppose there is always a way, but I've neve... Feb 22 2004, 08:36 PM Gint Because the motor turns twice for every one revolu... Feb 22 2004, 09:49 PM mike_the_man Out of curiousity, what happens if you don't r... Feb 23 2004, 11:18 AM Dave_Darling It won't automatically wreck anything, but you... Feb 23 2004, 12:39 PM mike_the_man The O ring is just rubber, right? So, if I just c... Feb 23 2004, 01:17 PM ThinAir914 nebreitling i unwittingly did this recently. i didn't put... Feb 23 2004, 05:03 PM
Eric Taylor Well I got the trigger's installed alright, th... Feb 23 2004, 08:19 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 16th June 2024 - 02:12 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.