 FI Trigger Points Install, How to do it? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Eric Taylor |
 Feb 22 2004, 04:16 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 909 Joined: 1-June 03 From: Newport, OR/Eugene Oregon- UO Member No.: 770  |
What's the best way of installing the trigger points for the injectors? Do I need to remove the distro?
Thanks, Eric |
   |
 
|
  |
Replies
| ThinAir |
Feb 22 2004, 08:36 PM
Post
#2
|
|
Best friends Group: Members Posts: 2,543 Joined: 4-February 03 From: Flagstaff, AZ Member No.: 231 Region Association: Southwest Region 
|
I suppose there is always a way, but I've never found it. Although I did have a Datsun pick once where the distributor shaft was installed 180 degrees out, but then I had to put the dizzy in 180 out as well. You gotta work pretty hard I think to get the dizzy installed 180 out if the distributor shaft is correctly installed.
|
|
|
|
Posts in this topic
Eric Taylor FI Trigger Points Install Feb 22 2004, 04:16 PM
type47 really, you do, unless you are a contorsionist. im... Feb 22 2004, 04:21 PM McMark Yes, remove the dizzy. Make sure to unbolt the cl... Feb 22 2004, 04:53 PM Eric Taylor I did a test dizzy removal on the 2.0 wreck and it... Feb 22 2004, 05:16 PM Dave_Darling You will need to re-set the timing. You'll ge... Feb 22 2004, 05:27 PM Eric Taylor So it is ok to pull it like that? I was very afrai... Feb 22 2004, 05:29 PM ChrisReale Take the dizzy out. Inspect the gasket also. It ... Feb 22 2004, 05:45 PM ThinAir914 <... Feb 22 2004, 08:19 PM Gint Because the motor turns twice for every one revolu... Feb 22 2004, 09:49 PM mike_the_man Out of curiousity, what happens if you don't r... Feb 23 2004, 11:18 AM Dave_Darling It won't automatically wreck anything, but you... Feb 23 2004, 12:39 PM mike_the_man The O ring is just rubber, right? So, if I just c... Feb 23 2004, 01:17 PM ThinAir914 nebreitling i unwittingly did this recently. i didn't put... Feb 23 2004, 05:03 PM
Eric Taylor Well I got the trigger's installed alright, th... Feb 23 2004, 08:19 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 15th June 2024 - 10:42 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.