 FI Trigger Points Install, How to do it? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Eric Taylor |
 Feb 22 2004, 04:16 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 909 Joined: 1-June 03 From: Newport, OR/Eugene Oregon- UO Member No.: 770  |
What's the best way of installing the trigger points for the injectors? Do I need to remove the distro?
Thanks, Eric |
   |
 
|
  |
Replies
| mike_the_man |
Feb 23 2004, 01:17 PM
Post
#2
|
|
I like stuff! Group: Members Posts: 1,338 Joined: 11-June 03 From: Regina, Saskatchewan, Canada Member No.: 809 |
The O ring is just rubber, right? So, if I just check it and make sure that it's all good, it should be ok? How much oild would squirt out if there is some minor scratching? I'll inspect closer tonight and figure out what to do. Oops.
|
|
|
|
Posts in this topic
Eric Taylor FI Trigger Points Install Feb 22 2004, 04:16 PM
type47 really, you do, unless you are a contorsionist. im... Feb 22 2004, 04:21 PM McMark Yes, remove the dizzy. Make sure to unbolt the cl... Feb 22 2004, 04:53 PM Eric Taylor I did a test dizzy removal on the 2.0 wreck and it... Feb 22 2004, 05:16 PM Dave_Darling You will need to re-set the timing. You'll ge... Feb 22 2004, 05:27 PM Eric Taylor So it is ok to pull it like that? I was very afrai... Feb 22 2004, 05:29 PM ChrisReale Take the dizzy out. Inspect the gasket also. It ... Feb 22 2004, 05:45 PM ThinAir914 <... Feb 22 2004, 08:19 PM ThinAir914 I suppose there is always a way, but I've neve... Feb 22 2004, 08:36 PM Gint Because the motor turns twice for every one revolu... Feb 22 2004, 09:49 PM mike_the_man Out of curiousity, what happens if you don't r... Feb 23 2004, 11:18 AM Dave_Darling It won't automatically wreck anything, but you... Feb 23 2004, 12:39 PM ThinAir914 nebreitling i unwittingly did this recently. i didn't put... Feb 23 2004, 05:03 PM
Eric Taylor Well I got the trigger's installed alright, th... Feb 23 2004, 08:19 PM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 15th June 2024 - 11:56 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.