 Case inspection prior to rebuild |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Cevan |
 Dec 20 2009, 09:10 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,079 Joined: 11-December 06 From: Western Massachusetts Member No.: 7,351  |
What is the normal practice in terms of inspecting the case halves prior to a rebuild? Is this something I can do myself?
All the bearing surfaces looked fine and the connecting rod play was between .008 and .010. Assuming I don't see any visual signs of damage, does it need to be sent to a professional who I assume has an expensive tool that checks the alignbore? |
   |
 
|
  |
Replies
| Jake Raby |
Dec 21 2009, 07:23 PM
Post
#2
|
|
Engine Surgeon Group: Members Posts: 9,398 Joined: 31-August 03 From: Lost Member No.: 1,095 Region Association: South East States |
Yes, studs need to be removed to do the procedure thoroughly.
After almost 4 decades of use most cases require some intervention. Recognizing what needs to be done is primary.. Actually doing it is secondary. |
|
|
|
Posts in this topic
Cevan Case inspection prior to rebuild Dec 20 2009, 09:10 AM
DNHunt If you have a dial bore gauge you can measure the ... Dec 20 2009, 09:53 AM Cevan There are at least 3 shops in my area that work on... Dec 20 2009, 12:06 PM hcdmueller Make sure you get the registers checked out. I ha... Dec 20 2009, 02:44 PM HAM Inc Less than an hour ago I decked the case that we... Dec 20 2009, 03:54 PM davep Len, In your experience, is the sagging more an is... Dec 21 2009, 12:34 PM r_towle Chris,
For a farmer check...for those of us at hom... Dec 21 2009, 01:13 PM underthetire
What is the normal practice in terms of inspectin... Dec 21 2009, 01:30 PM
Cevan
What is the normal practice in terms of inspecti... Dec 21 2009, 03:06 PM underthetire Oh, sorry. Thought you meant bearing clearance. My... Dec 21 2009, 03:10 PM HAM Inc
Dave I don't see to many of the cases I deck ... Dec 21 2009, 04:10 PM Cevan
If the head studs are removed I charge $150.... Dec 21 2009, 06:35 PM ConeDodger All three cases that I have checked had sunk at th... Dec 21 2009, 04:42 PM r_towle Chris,
Contact William Harris via this site.
He u... Dec 21 2009, 08:04 PM HAM Inc
Yes, the studs should come out. Use heat if you h... Dec 22 2009, 09:19 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st July 2025 - 05:17 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.