 Carb assistance |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| RonnieJ |
 Jan 10 2010, 11:39 AM
Post
#1
|
|
RonnieJ  Group: Members Posts: 230 Joined: 16-June 03 From: Sterling Heights, Michigan Member No.: 829 Region Association: Upper MidWest  |
Is there a way to set up a choke on dual weber 40mm's.
|
   |
 
|
  |
Replies
| Rav914 |
Jan 10 2010, 03:15 PM
Post
#2
|
|
All-weather fan Group: Members Posts: 740 Joined: 15-April 07 From: WA Member No.: 7,669 Region Association: None |
I intend to buy this kit and attach it under the dash. In broad strokes my plan is to run the cable either under the gas tank and back in the cockpit in front of the pedal cluster, or inside along the chassis going forward and over the gas pedal. Then it'll attach it to the front of the gas pedal linkage plate on the cluster. A little pull on the near-hidden knob will pull the linkage assembly forward and I should get an increased idle until warm. Viola, instant choke.
Not all pieces will be used. Most likely just the bracket and cable with handle. The rest will come from the hardware store. Attached image(s) 
|
|
|
|
Posts in this topic
RonnieJ Carb assistance Jan 10 2010, 11:39 AM
McMark Some of them. There is a gold plate on the side h... Jan 10 2010, 12:06 PM
RonnieJ
Some of them. There is a gold plate on the side ... Jan 10 2010, 02:31 PM McMark An even better solution would be to convince Bruce... Jan 10 2010, 12:08 PM McMark Nate, You might find that the choke cable will res... Jan 10 2010, 03:34 PM Rav914 Good point. Thanks for the head's up.
Back t... Jan 10 2010, 04:50 PM RonnieJ
Good point. Thanks for the head's up.
Back ... Jan 10 2010, 06:43 PM Jake Raby If the engine needs chokes to fire up when cold, t... Jan 10 2010, 07:43 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th July 2025 - 01:27 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.