 sputtering 1.7 FI, what do i need to do |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Freedom |
 Mar 2 2004, 09:45 PM
Post
#1
|
|
Member  Group: Members Posts: 79 Joined: 26-February 04 From: Colorado Member No.: 1,722  |
well first of all i replaced all of the vacuum lines, ran some injector clearer through it and checked the timing and replaced the plugs, points and wires, cap rotor...blah blah blah... i cannot figure out whant next. i took the TB off and cleaned it removed the decel valve it ran worse. and got rid of the emissions canister.. what next before i go out of my mind!!.
|
   |
 
|
  |
Replies
| Nemo914 |
Mar 3 2004, 06:07 PM
Post
#2
|
|
Member Group: Members Posts: 76 Joined: 11-July 03 From: Cape Cod, MA Member No.: 902 |
Non an expert here, but when my car had a similar issue, it was simply a bad head temperature sensor. It only cost 20-30 bucks and is an easy swap, although a bit tough to get to. Good luck.
|
|
|
|
Posts in this topic
Freedom sputtering 1.7 FI Mar 2 2004, 09:45 PM
vsg914 What exactly is it doing? sputtering is kinda gene... Mar 2 2004, 09:55 PM Freedom i replaced the points.
the car is really under po... Mar 2 2004, 10:01 PM nebreitling ignition points or fuel injection trigger points?
... Mar 2 2004, 10:05 PM vsg914 Hmm, have you set the dwell with a meter? Sounds l... Mar 2 2004, 10:06 PM JOHNMAN If you believe it is a fuel problem, have you chec... Mar 2 2004, 10:12 PM garyh I had a similar problem. Turned out to be two clo... Mar 2 2004, 10:13 PM weird_looking_cactus haha sounds like my car when I had it running I ju... Mar 2 2004, 10:15 PM vsg914 fuel pressure=29psi. Sounds electrical to me. Mar 2 2004, 10:16 PM garyh Freedom pulled the TPS it seemed okay i cleaned it out all... Mar 2 2004, 10:32 PM vsg914 Fuel injection trigger points are in the lower par... Mar 2 2004, 10:39 PM nebreitling yup, triggerpoints could cause your problems. pul... Mar 2 2004, 10:48 PM Freedom where can i get trigger points?... and also what s... Mar 2 2004, 11:19 PM nebreitling garyh JOHNMAN I just had a strange notion and don't know if ... Mar 3 2004, 12:17 AM rhodyguy kris, do you have the plug wires on in the correct... Mar 3 2004, 08:45 AM Dave_Darling The Crane for the 009 distributor may or may not w... Mar 3 2004, 11:52 AM Freedom well i adjusted the valves when i got the car, cha... Mar 3 2004, 04:14 PM Dave_Darling 
Freedom checked the FP and it is holding at 29psi... the ... Mar 5 2004, 04:18 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 3rd July 2025 - 01:44 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.