 Push rod tube seals, any sealent required? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| 914rat |
 Apr 7 2010, 01:38 PM
Post
#1
|
|
Member  Group: Members Posts: 279 Joined: 3-July 06 From: Maryland Member No.: 6,362  |
I pulled my heads and will replace the tube seals was wondering if there is anything I should put on the seals besides some oil?
|
   |
 
|
  |
Replies
| Al Meredith |
Apr 8 2010, 10:07 AM
Post
#2
|
|
Senior Member Group: Members Posts: 960 Joined: 4-November 04 From: Atlanta, ga Member No.: 3,061 |
I use a "dingleberry" hone on the head to assure a clean surface for the Oring to seal. Put a little grease on the Oring so it rolls in , and use a flashlight to inspect the installation.
|
|
|
|
Posts in this topic
914rat Push rod tube seals Apr 7 2010, 01:38 PM
DanT nope :D Apr 7 2010, 01:41 PM dr914@autoatlanta.com
I pulled my heads and will replace the tube seals... Apr 7 2010, 01:41 PM 914rat Thanks :D Apr 7 2010, 03:48 PM URY914 :agree: Apr 7 2010, 06:18 PM Cap'n Krusty I hope you didn't pull the heads just to repla... Apr 7 2010, 07:20 PM
914rat
I hope you didn't pull the heads just to repl... Apr 8 2010, 01:30 PM realred914 get the holes the o-ring goes into very very clean... Apr 7 2010, 10:35 PM Jake Raby I have applied them in the conventional manner as ... Apr 8 2010, 01:13 PM Mark Henry I've also used used Jake's method and it w... Apr 8 2010, 01:24 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st June 2024 - 12:16 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.