 end play gone wrong? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| TheCabinetmaker |
 Aug 21 2010, 08:22 PM
Post
#1
|
|
I drive my car everyday  Group: Members Posts: 8,336 Joined: 8-May 03 From: Tulsa, Ok. Member No.: 666  |
I've had the engine out of the car to fix some oil leaks and upon removing the flywheel, there was only two shims, and one of them was just about destroyed. Does anyone see anything wrong with this pic? (besides the oil everywhere!) (IMG:http://www.914world.com/bbs2/uploads_offsite/i290.photobucket.com-666-1282443773.1.jpg) |
   |
 
|
  |
Replies
| Bartlett 914 |
Aug 22 2010, 01:11 PM
Post
#2
|
|
Advanced Member Group: Members Posts: 2,218 Joined: 30-August 05 From: South Elgin IL Member No.: 4,707 Region Association: Upper MidWest |
Hard to tell from the picture but it looks like a smaller dia shim is stuck in there. It is no longer round.
|
 |
|
| TheCabinetmaker |
Aug 22 2010, 01:32 PM
Post
#3
|
|
I drive my car everyday Group: Members Posts: 8,336 Joined: 8-May 03 From: Tulsa, Ok. Member No.: 666 |
QUOTE(Bartlett 914 @ Aug 22 2010, 02:11 PM)  Hard to tell from the picture but it looks like a smaller dia shim is stuck in there. It is no longer round. That smaller diameter shim is actually the end of the main bearing. |
|
|
|
Posts in this topic
vsg914 end play gone wrong? Aug 21 2010, 08:22 PM
vsg914 47 views and no comments? You guys are slipping. Aug 22 2010, 10:40 AM BMXerror
Does anyone see anything wrong with this pic?
... Aug 22 2010, 10:46 AM
vsg914 I did check end play with no shims. it measured 2.... Aug 22 2010, 01:30 PM Mark Henry Your trust is fuched, tear down time.
If you can... Aug 22 2010, 01:37 PM
vsg914 Good eye Mark! The end of the thrust that lips... Aug 22 2010, 01:53 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 01:57 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.