 carb popping 6 this time, everybody loves carb threads |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| dem |
 Nov 26 2010, 10:59 AM
Post
#1
|
|
Rusty Member  Group: Members Posts: 147 Joined: 7-February 10 From: Cupertino, CA Member No.: 11,334 Region Association: Northern California  |
Drove the 914 to turkey time yesterday, about 50 miles of backroads. Seemed to be runnin' about normal with the usual symphony of only-occasional random backfires and pops. It was, of course, ridiculously fun.
Car sat til I left around 10 PM, and by then it was around 40 degrees outside. Lots of popping and stuttering at part throttle. Full throttle and it was the usual fun excitement. The ride home on the freeway was unpleasant because the 2.7L doesn't need much throttle to keep my little car moving. Could this just be temperature related? Idle jets sized for Los Angeles (where I bought it.)? Otherwise I assume I'm looking at checking for gunk in the idle jets, I assume. This is my first carbed porsche, so I guess it is time to really "grok" them. Is there an obvious "start here carb newbie" direction? Book and/or web site? Googling turns up tons and tons of random stuff. Thanks. |
   |
 
|
  |
Replies
| Justinp71 |
Dec 16 2010, 10:04 PM
Post
#2
|
|
Senior Member Group: Members Posts: 1,639 Joined: 11-October 04 From: Sacramento, CA Member No.: 2,922 Region Association: None 
|
One thing I learned about keeping the carbs clean is that you have to make sure you have good air filtration. Some say to use a film of grease between the air filter and air cleaner. I have heard that k&n air filters dont keep carbs clean enough (yet I still run them ). Also run plenty of fuel filters.
|
|
|
|
Posts in this topic
dem carb popping 6 this time Nov 26 2010, 10:59 AM
sean_v8_914 pretend you have an early 911 and search web acord... Nov 26 2010, 11:36 AM J P Stein Years back... early one morning in the spring I wa... Nov 26 2010, 12:02 PM Cap'n Krusty I could be wrong, but I don't think being 300 ... Nov 26 2010, 12:25 PM
Cupomeat
I could be wrong, but I don't think being 300... Dec 12 2010, 07:02 PM dem Cleaned the idle jets with compressed air and carb... Nov 26 2010, 04:13 PM J P Stein Your first post told me it wasn't running righ... Nov 27 2010, 12:23 PM dem I've spent the last 24 hours reading tons of t... Nov 27 2010, 12:53 PM J P Stein Get the float setting tool while you're at it.... Nov 27 2010, 01:22 PM dem Pulled and clean the idle jets.. no change.
Pull... Dec 1 2010, 08:20 PM dem Ok, I bought 5 books and googled a lot.. bought t... Dec 11 2010, 02:47 PM SirAndy Two of the idle mixture screws (#5 and #6) did not... Dec 11 2010, 04:51 PM Mark Henry
I am, of course, terrified of running lean.
A... Dec 12 2010, 12:09 AM john rogers You seem to be getting on the right track. Several... Dec 11 2010, 03:41 PM dem I try to drive it to full operating temperature at... Dec 11 2010, 05:28 PM 9146986 Do you mean 5.5 half turns out or 5.5 full turns? ... Dec 11 2010, 06:44 PM dem
Do you mean 5.5 half turns out or 5.5 full turns?... Dec 11 2010, 06:48 PM sww914 The inside of the engine doesn't care how many... Dec 11 2010, 07:51 PM jt914-6 Here's a site I ran across that may help you..... Dec 12 2010, 07:01 AM dem Thanks everyone for the tips - I took the car out ... Dec 12 2010, 01:25 PM J P Stein Side to side balance is adjusted with the down lin... Dec 12 2010, 04:57 PM Rusty Dem, I'm a little late here.
I struggled with... Dec 14 2010, 12:02 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 3rd July 2025 - 02:57 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.