 Fuel pump wire number, on the realy board |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| toon1 |
 Jan 11 2011, 08:21 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,849 Joined: 29-October 05 From: tracy,ca Member No.: 5,022  |
what is the pin number on the connector on the relay board for the fuel pump?
I am going to use it for the AAR. It's been so long since I've messed around with the relay board, I've forgotten. Thanks |
   |
 
|
  |
Replies
| toon1 |
Jan 13 2011, 08:47 AM
Post
#2
|
|
Senior Member Group: Members Posts: 1,849 Joined: 29-October 05 From: tracy,ca Member No.: 5,022 |
Looking at the diagram Andy posted, pin 13, which looks like the FP pin is tied into pin 12 which looks like the pin for the AAR.
If I ran a ground wire to activate the FP circut again, this should activate pin 12 for the AAR correct? |
|
|
|
Posts in this topic
toon1 Fuel pump wire number Jan 11 2011, 08:21 PM
SirAndy
what is the pin number on the connector on the re... Jan 11 2011, 09:07 PM toon1 Thanks Andy, It looks like the AAR is connected to... Jan 11 2011, 09:30 PM JamesM From what i recall when last digging into it, AAR ... Jan 11 2011, 09:57 PM toon1 I'm running a Megasquirt FI. It has the capabi... Jan 11 2011, 10:06 PM
JamesM
I'm running a Megasquirt FI. It has the capab... Jan 11 2011, 11:54 PM underthetire
I'm running a Megasquirt FI. It has the capa... Jan 12 2011, 05:15 PM underthetire Just tie it in to a spare port on your megasquirt.... Jan 11 2011, 10:07 PM toon1 You're correct, I forgot about the Stock ECU t... Jan 12 2011, 12:05 PM SirAndy If you come across how to activate the FP WITHOUT ... Jan 12 2011, 12:51 PM JamesM
You're correct, I forgot about the Stock ECU ... Jan 13 2011, 01:07 AM toon1
If you come across how to activate the FP WITHOUT... Jan 12 2011, 01:59 PM toon1 before I rebuilt the motor, I had mine setup like ... Jan 12 2011, 06:17 PM underthetire
before I rebuilt the motor, I had mine setup like... Jan 12 2011, 06:20 PM toon1 Thanks, I have an old stim board, I dont think it ... Jan 12 2011, 06:54 PM underthetire That's what it looks like to me. Jan 13 2011, 04:34 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 8th June 2024 - 08:11 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.